Precision

• No obstructing chuck jaws – clamping achieved of the bottom face only
• ID and OD finished in the same operation – promotes concentricity & perpendicularity
• Doesn’t distort or squeeze the part like traditional clamps

Optional Top Tooling

• If needed self shimming pole extensions can be used to clamp the part in the “free state” to prevent warping
• Fixed pole extensions can be used to raise the part off the surface of the magnet increasing tool access to the full OD and ID faces

Multiple Connection Options

• Through-spindle rotary electrical connections for full machine integration
• External connector for simple installation/retrofit

Advanced Control

• Contains all fail-safe features of WEN square pole chuck controls
• Independent verification of magnetization
• Cycle start inhibit if chuck is not fully magnetized
• Chuck status light tower

Electro-Permanent Magnetic Circuit

• Permanent Magnets hold the part, if electrical power fails, the chuck will not let go of the part
• Single-Magnet circuit available for high alloy/hard parts – fully demagnetizes work-piece, and it will not have any residual magnetism
• Double-Magnet circuit available for maximum holding force

FULL BROCHURE